S05 12/24/48/110 -5K0-TERT
Home » Products » Surge Protection Device » SSPD » Signal SPD » S05 12/24/48/110 -5K0-TERT

loading

Share to:
facebook sharing button
twitter sharing button
line sharing button
wechat sharing button
linkedin sharing button
pinterest sharing button
whatsapp sharing button
sharethis sharing button

S05 12/24/48/110 -5K0-TERT

It is suitable for lightning protection of control signals and twisted-pair data lines. It can prevent permanent damage or instantaneous interruption to various signal equipment or systems caused by induced overvoltage, overcurrent and other instantaneous surge voltages caused by lightning strikes or industrial noise. and other hazards.
Availability:
Quantity:

Model

S05(12/24/48/110)-5KO-TERT

According to standards: GB/T18802.11(IEC61643-21)

C2

Nominal  voltage (Un)

5V/ 12V/24V/48V/110V

Maximum continuous operating voltage (Uc)

8V/15V/30V/60V/150V

Nominal discharge current (8/20μs) [ln]

5KA

Voltage Protection Level (Up)[Line to Line]

80V/80V/80V/150V/350V

Voltage Protection Level (Up)[Line to Ground]

150V/150V/150V/300V/500V

Transmission rate


2MHz


Insertion loss

≤0.2dB(at 2MHz),≤0.5dB(at 10MHz)

Response time (t)


≤1ns


Operating temperature range (Tu)

-40℃~+70°C

Working status/fault indication

-
Maximum load current 1A

Minimum installation conductor cross-sectional area

0.5mm²; single strand/multiple strands

Maximum installation conductor cross-sectional area

2.5mm²; single strand/multiple strands

Installation method

35mm DIN rail according to EN 60715

Shell material

Gray thermoplastic, UL94 V-0

Installation Location

Indoor

Protection level

IP20

Size

0.4 digital analog, DIN 43880

Relative humidity

≤95% no condensation


1. The lightning arrester is connected in series between the signal channel and the protected equipment.

2. Reliably connect the lightning arrester to the ground wire equalizing ring of the lightning protection system. The length of the ground wire should be less than 0.5mm.

3. Lightning arresters require no special maintenance. When the system fails and the lightning arrester is suspected, the lightning arrester can be removed and then checked. If the system returns to normal after returning to the state before use, it means that the lightning arrester has been damaged and the lightning arrester should be replaced.


Previous: 
Next: 

Product Category

Quick Links

Solution

Automotive System
Industrial Instrumentation
USB Interface
Sign up for our newsletter

OUR PRODUCTS

ABOUT US

MORE LINKS

CONTACT US

F4, #9 Tus-Caohejing Sceience Park,
No.199 Guangfulin E Road, Shanghai 201613
Phone: +86-13654948860
Fax : +86-21-67689607
Email: trade@yint.com.cn

SOCIAL NETWORKS

Copyright © 2024 Yint Electronic All Rights Reserved. Sitemap. Privacy Policy. Supported by leadong.com.