S12-10K-TK
Home » Products » Surge Protection Device » SSPD » Antenna SPD » S12-10K-TK

loading

Share to:
facebook sharing button
twitter sharing button
line sharing button
wechat sharing button
linkedin sharing button
pinterest sharing button
whatsapp sharing button
sharethis sharing button

S12-10K-TK

Mainly suitable for antenna feeder equipment of communication systems such as mobile communication base stations, wireless local calls, mobile communication TD-SCDMA, GPRS global locator, MMDS microwave spread spectrum communication, satellite and microwave communication transceiver stations. In the transceiver system, it can effectively prevent the above electronic Damage caused by information equipment being impacted by lightning waves.
Availability:
Quantity:

Model

S12-10K-TK

According to standards: GB/T18802.11(IEC61643-21)

C2

Nominal voltage(Un)

12V

Maximum continuous operating voltage (Uc)

18V

Nominal discharge current (8/20μs) [ln]

10KA

Inrush current (10/350us) [limpl

2.5KA

Voltage protection level (Up)

1KV

Transmission rate

0~2.5GHz

Insertion loss

≤0.5dB

standing wave ratio

≤1.2

Response time (t)

≤100ns

Operating temperature range (Tu)

-40℃~+80°C

Applicable network equipment

Antenna and feeder equipment
Maximum load current 1A
Cross-sectional area of conductor

2.5mm² multiple strands

Installation method

Threaded connection

shell material

brass

Installation method

35mm DIN rail according to EN 60715

Shell material

Gray thermoplastic, UL94 V-0

Installation Location

Indoor/outdoor

Protection level

IP20

Relative humidity

≤95% no condensation


1. The lightning arrester is connected in series between the signal channel and the protected equipment.

2. Reliably connect the lightning arrester to the ground wire voltage equalizing ring of the lightning protection system. The length of the ground wire should be less than 0.5m.

3. Lightning arresters require no special maintenance. When the system fails and the lightning arrester is suspected, the lightning arrester can be removed and then checked. If the system returns to normal after returning to the state before use, it means that the lightning arrester has been damaged and the lightning arrester should be replaced.


Previous: 
Next: 

Product Category

Quick Links

Solution

Automotive System
Industrial Instrumentation
USB Interface
Sign up for our newsletter

OUR PRODUCTS

ABOUT US

MORE LINKS

CONTACT US

F4, #9 Tus-Caohejing Sceience Park,
No.199 Guangfulin E Road, Shanghai 201613
Phone: +86-13654948860
Fax : +86-21-67689607
Email: trade@yint.com.cn

SOCIAL NETWORKS

Copyright © 2024 Yint Electronic All Rights Reserved. Sitemap. Privacy Policy. Supported by leadong.com.